Rubber mallet, pencil, steel ruler, tape measure, electric jigsaw or table saw, eye protectors, knee pads, stiff broom
- Sweep dirt out of garage and fill in any major cracks with readily available floor leveller.
- Fit tapered ramp (entrance doorstrips) where necessary then align and join the tiles into place using a rubber mallet.
- Carefully cut the tiles when you reach your walls using an electric jigsaw or table saw.
- Make sure you leave a minimum gap of 5mm from the walls to allow for expansion.
Regularly sweeping your floor is advised.
For a thorough clean we recommend using a PH neutral floor cleaner, it easily removes dirty marks and makes your floor look as good as new!
View our FAQ's for further information on
installation and maintenance.